Adjusting The Monitor; System Settings - Renfert EASY view 3D Guia De Inicio Rapido

Connecting the monitor
⇒ Monitor cable ==> DVI input of the monitor (41).
⇒ Secure plug with integrated screws.
EN
⇒ Power supply ==> DC 12 V (40).
Ensure that the color coding is correct between the connection
cable and socket!
⇒ Insert the power cord into the power supply unit and into the building
wall socket.
Operation
Switching on
⇒ Switch on the monitor by pressing the power button (8).
⇒ Switch on the head using the power switch (7).
♦ The lighting goes on.
♦ After about 20 seconds, an image appears on the monitor.
The cone of light on the table top describes an area whose center is captured by the optics.
Stand-by
If there is no movement below the head for more than 10 minutes and the mouse has not been moved for more than
10 minutes, the lighting and the monitor output are switched off (monitor power button (8) flashes).
The stand-by mode is ended when the mouse is moved or movement takes place in the detection range of the optics.

Adjusting the monitor

In most cases, the monitor can be used with its basic settings.
Details on the monitor can be found in the instructions for use in the internet.
Set up
There are two options for focusing the image:
• Coarse adjustment by moving the head with the support arm.
• Fine adjustment through height adjustment (6).
The following procedure is recommended:
⇒ Align the head parallel to the table.
⇒ Place the object on the desk pad within the cone of light.
⇒ Set the head to the middle of the height adjustment.
⇒ Set the head on the support arm so that the object can be seen on the monitor and if necessary adjust the height
adjustment.
This allows you to quickly correct the focus for objects with different heights.

System settings

The current settings of the system are displayed on the monitor at the bottom left.
As soon as the mouse is moved, the monitor displays the available settings and with which element of the mouse the
setting can be changed.
2D / 3D representation
⇒ Left mouse button (A)
♦ Switch between 2D and 3D
display
In addition, the current IP address and the host name of the EASY view 3D head are displayed.
Magnification (15 x, 20 x)
A
⇒ Mouse wheel (B) rotation forward /
backward
♦ Switch of magnification between
⇒ Press / rotate the mouse wheel (B)
♦ Adjust the brightness of an
B
15 x and 20 x
object mode (see instructions for
use on the internet).
- 4 -
40
41
Object mode (ceramic, metal,
standard, neutral)
C
⇒ Right mouse button (C)
♦ Switch object modes