5.4
Filter Cleaning
In order to guarantee maximum suction performance, the unit is equipped with an automatic cleaning
function for the filter unit. The cleaning function takes approx. 8 sec.
EN
The cleaning process is carried out:
• When the unit is switched on;
• Before the dust drawer is removed, when the cleaning function is activated (see chapter 6�2 Empty dust
drawer);
• When the unit has been in operation (turbine running time) for more than 16 hrs without having been
switched off in between�
After an automatic filter cleaning, in case of a renewed drop of the flow velocity, the next filter
cleaning will be performed only after 2 hours of turbine running time.
5.5
Automatic Switch-on for Automatic Operation
The switch-on threshold, which activates and deactivates the suction
function when a connected electrical device is operated, can be set�
♦ Automatic mode is selected; the display (20) lights up (if the unit is
not already in this mode, switch to automatic mode)�
⇒ Press the operation mode key (21) for at least 3 seconds�
♦ The display for automatic operation (20) blinks�
♦ The display for continuous operation (22) is off�
⇒ Switch the electronic device off or switch the device to stand-by
mode (e�g� with a handpiece, only switch the control device on with-
out activating the handpiece)�
⇒ Press the enter key (25)�
♦ The display automatic operation (20) lights up�
♦ The display continuous operation (22) blinks�
♦ An acoustic signal will confirm the setting.
⇒ Switch the electronic device on, e�g� activate the handpiece at the rpm at which the extraction unit
should function and let it run for 3 - 5 seconds (to allow for over currents which occur when the device is
initially switched on)�
⇒ Press the enter key (25) (whilst the handpiece is still in use)�
♦ The display for automatic operation (20) and continuous operation (22) light up at the same time for
approx� 2 seconds�
♦ An acoustic signal confirms the setting.
Devices with a stand-by mode should be switched on approx. 5 minutes before setting, in order to
prevent measurement errors.
If an error occurs during the setting of the switch-on function, the display error (26, Fig. 2) lights
up and an acoustic signal is emitted three times.Press Enter key (25) and restart the setting.
5.6
Deactivating the automatic start in the automatic operation mode
This special function allows the automatic ex-
traction start in the automatic operation mode to
be temporarily deactivated, e�g� when handpiece
use is required without suction�
This special function is only available in the auto-
matic operation mode�
♦ The automatic function is set (display (20) is
alight)�
⇒ Press the suction level key (23) for at least
3 seconds�
♦ An acoustic signal will confirm the deactivation.
♦ The display automatic operation (20) blinks�
In order to re-activate the automatic start:
⇒ Press keys (21, 23 or 25), or
⇒ switch the unit off at the on/off switch (9, Fig� 1)�
20
21
- 10 -
20
21
22
23
25
Fig. 9
25
Fig. 10