About This Document; General Safety Precautions; Electrical Connection - STEINEL IR 180 UP easy Manual De Instrucciones

GB

1. About this document

Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in Whole or in part only With our
consent.
– Subject to change in the interest of technical progress.
– All product dimensions in mm.
Symbols
!
Hazard Warning!
Reference to other information in the document.
...

2. General safety precautions

Disconnect the power supply before attempting any
!
Work
on the sensor switch.
• During installation, the electric power cable being connected must not be
live. Therefore, switch off the power first and use a voltage tester to make
sure the Wiring is off-circuit.
•
• Installing the sensor switch involves work on the mains voltage supply.
This work must therefore be carried out professionally in accordance with
national wiring regulations and electrical operating conditions (e.g.
DE: VDE 0100, AT: OVE-EN 1, CH: SEV 1000).
3. IR 180 UP easy/IR 180 AP
Proper use - IR 180 UP easy:
– Sensor switch for concealed installation in dry interior spaces.
Proper use - IR 180 AP easy:
– Sensor switch for surface installation in dry interior spaces and those
exposed to moisture.
easy
- 24 -
The sensor switches are equipped with a pyro sensor which detects the invisible
heat emitted by moving objects (people, animals etc.). The heat detected in this
way is converted electronically into a signal that switches a connected load ON
(e.g. a light).
Heat is not detected through obstacles, such as walls or panes of glass, and will
therefore not activate the light.
The sensor switch is designed for both 2 and 3-wire electrical systems.
Package contents - IR 180 UP easy (Fig. 3.1)
Package contents - IR 180 AP easy (Fig. 3.2 )
Product dimensions - IR 180 UP easy (Fig. 3.3)
Product dimensions - IR 180 AP easy (Fig. 3.4)
Product components - IR 180 UP easy (Fig. 3.5)
A Load module
B Twilight setting
C Time setting
D Connecting terminal screw shaft
E Connecting terminal cable duct
F Surround
G Sensor module
H Switch for light function
Product components - IR 180 AP easy (Fig. 3.6)
A Surface-mounting enclosure
B Twilight setting
C Time setting
D Connecting terminal screw shaft
E Connecting terminal cable duct
F Load module
G Sensor module
H Switch for light function
I Cover
Detection zone (Fig. 3.7)

4. Electrical connection

Connection wiring diagram: two-wire (Fig. 4.1)
Connection wiring diagram: three-wire (Fig. 4.2)
Connection wiring diagram: interconnecting several sensor switches (Fig. 4.3)
- 25 -