Operating The Handbike Batec Electric Mini 2 / Electric 2 (Rapid 2) / Scrambler 2 Hemi Controls - BATEC MINI 2 Manual De Usuario

• Brake: Push the HANDBIKE BATEC ELECTRIC QUAD MINI handlebar
a ay from you to activate the bra e.
• Front and back gears:
– There are t o operating modes: Front and bac gears:
– In front gear, there are speed limits (position 1, position 2 and
position ), each ith a light indicator on the display panel.
– In back gear, there is only one speed and one light indicator on the
display panel.
– hen the HANDBIKE BATEC ELECTRIC is s itched on, it ill al ays
be in front gear, position 1.
– In front gear, press button F to choose the desired speed limit (po-
sition 1, position 2 or position ).
– Press the R button to s itch to bac gear. This mode ill only be acti-
vated if the HANDBIKE BATEC ELECTRIC is sopped and the throttle is
not engaged. Press the F button to switch back to front gear.
• Free heel mode: To use the HANDBIKE BATEC ELECTRIC in free-
heel mode:
– S itch the device o ith the ey.
– To move for ards or bac ards, use the rims on the
to move the HANDBIKE BATEC ELECTRIC and heelchair in the de-
sired direction.
– To turn, turn the HANDBIKE BATEC ELECTRIC with one hand while
propelling the wheelchair with the other.
– To stop, use the HANDBIKE BATEC ELECTRIC bra es or the rim on
the wheelchair.
• Lights: There is a button on the HANDBIKE BATEC ELECTRIC handlebar
to s itch on the front and rear lights.
front light ill go on in normal mode and the light indicator on the dis-
play panel ill turn green. hen you push the front light button again,
it changes to high beam mode, and so on. To turn o the lights, hold
the button down for 2 seconds. The front light is below the battery and
the t o rear lights, on either side of the stand frame.
– 28 –
( ee fig. 29)
( ee fig. 30)
heelchair
hen you push the button, the
( ee fig. 31a, 31b, 31c)
4.8. OPERATING THE HANDBIKE BATEC ELECTRIC MINI 2 /
ELECTRIC 2 (RAPID 2) / SCRAMBLER 2 HEMI CONTROLS
• You can find out the meaning of all the symbols used on the controls
of the BATEC ELECTRIC HANDBIKE in Figure 58.
• Turn on: Turn the key on the right side of the battery clockwise to the
ON position. It ill do a system chec : don t start using your HAND-
BIKE BATEC ELECTRIC until it has finished ith the system chec and
all the lights are on.
( ee fig. 32)
• Turn o : Turn the ey on the battery anti cloc
tion. If you leave it in the OPEN position, your HANDBIKE BATEC ELEC-
TRIC ill be o and the battery ill be ready to remove.
• Speed up: The throttle is on the right or left grip on the handlebar.
( ee fig. 33)
• Bra e: Pressing on the bra e lever and the red lever at the same time
blocks the brake lever, acting as a parking brake.
• Front and back gears:
– There are t o operating modes: Front and bac gears:
– In front gear, there are speed limits (position 1, position 2 and
position ), each ith a light indicator on the display panel.
– In back gear, there is only one speed and one light indicator on the
display panel.
– hen the HANDBIKE BATEC ELECTRIC is s itched on, it ill al ays
be in front gear, position 1.
– In front gear, press button F to choose the desired speed limit (po-
sition 1, position 2 or position ).
– Press the R button to s itch to bac gear. This mode ill only be ac-
tivated if the HANDBIKE BATEC ELECTRIC is sopped and the throttle
is not engaged. Press the F button to switch back to front gear.
fig. 35)
• Free heel mode: To use the HANDBIKE BATEC ELECTRIC in free-
heel mode:
– 29 –
ise to the OFF posi-
( ee fig. 32)
( ee fig. 34)
(See