Alpine XM HCE-100XM Manual De Operación página 12

Connections
NVE-N872A
XM compatible Navigation
(Sold separately)
XM Radio Tuner
(Sold separately)
1 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+) 12V
only when the ignition is turned on or in the accessory
position.
2 Battery Lead (Yellow)
Connect this lead to the positive (+) terminal of the vehicle's
battery.
3 Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
4 Fuse Holder (7.5A)
5 Power Supply Connector
6 Navigation Connection Cable (Included)
7 XM Antenna Output Connector (Black)
IGNITION
BATTERY
GND
6
!
9
Violet
Black
"
1
2
3
4
5
7
8
8 XM Antenna Input Connector (Violet)
Connect this to an optional XM antenna.
9 XM Tuner Cable (Included)
Connect the black connector of the cable to this receiver and
the violet connector to the XM radio tuner.
If required, use an optional splitter.*
! XM Antenna Connector
Depending on the XM tuner connector type, antenna
connection may not be possible.
" XM Antenna (Sold Separately)
* "NO SIGNAL" is displayed on the XM tuner if the XM
radio tuner cable is not connected when an optional
splitter is used.
• After connecting, confirm that "Traffic Receiver:
Connected" appears in the System Status display. (Refer to
"System Information" in the Owner's Manual of a NVD-
A801 series on page 57.)
Ignition Key
Battery
11
-EN