Light Kit Assembly - Craftmade ELLINGTON TRD60PLN4 Guia De Instalacion

9. Light Kit Assembly.

motor housing
Remove 3 screws from inside of fitter
plate--save screws for LED light kit attachment
later on.
Remove 1 screw from motor plate on
underside of motor housing and partially
motor plate
loosen the other 2 screws. Align slotted holes
in center of fitter plate with loosened screws
in motor plate, allowing male plug from
motor housing to come through hole in
fitter plate
middle of fitter plate. Twist fitter plate to lock.
male plug
Re-insert screw that was just removed and
securely tighten all 3 screws with Phillips
screwdriver.
Connect male plug from motor housing to
motor housing
female plug from LED light kit, matching up
the colors on the male plug with the colors on
the female plug for correct fit. Be sure that
plugs connect securely.
Arrange wires carefully within fitter plate.
Align holes in LED light kit with 3 small holes
fitter plate
in fitter plate. Re-insert 3 screws that were
male plug
previously removed and tighten all screws
securely.
female plug
Align grooves on glass shade with nodules on
LED light kit
inside of fitter plate and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade no longer turns.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
glass shade
page 8