Aqua Medic EcoDrift 4.0 Manual Del Usuario página 10

W1: Frequency and speed adjustment. Press SPEED button for S1 = 100 %, S2 = 75 %
and S3 = 50 %. Use control dial (4) to adjust frequency.
W2:
Slow flow rate increase to 100 % and slow decrease back to 0 %.
W3: Fast flow rate increase to 100 % and slow decrease to 0 %.
Lock: Prevents accidental program changes. Press SPEED/LOCK button to activate Lock
mode - Lock LED illuminates, control dial (Fig. 2, No. 4) is de-activated. Press
SPEED/LOCK button again for 5 sec. to de-activate Lock mode.
10 min.: Stops pump for 10 min. time period. Press MODE/FEED button for 5 sec., 10 min.
LED illuminates. To cancel the 10 min. program, press MODE/FEED button for 5 sec.
S1: 100 % flow rate, only with W1 program
S2: 75 % flow rate, only with W1 program
S3: 50 % flow rate, only with W1 program
Random: Random selection of above programs.
Night Mode: When connecting the light sensor, the night mode is activated and the L-Sensor
active LED illuminates. In night mode, during nighttime, the pump automatically switches a 50 %
continuous flow rate. The light sensor is connected to the left side at the controller. To use the night
function, the EcoDrift Control has to be attached to a lighted place, but not directly at a very bright
light source as this may damage the sensor. During daytime, the pump switches back to the set
program.
5. Cleaning and Maintenance
From time to time, the pump needs to be cleaned. First of all, remove the pump assembly from the
holder (6). Then, remove the rubber gaskets (Fig. 1, No. 4). Twist the filter basket (1) and remove
it from the pump housing (3). (Hold the pump assembly with your left hand. With your right hand,
twist the filter basket counterclockwise to unlock it from the pump housing). The filter basket can be
locked in various positions. Ideally, the cable should point vertically upwards.
After removal of the basket, the entire impeller unit can be pulled out. All components can be cleaned
under running water and be re-assembled again. During assembly, make sure the ceramic shaft fits
properly into the filter basket's socket.
6. Failures
The pump is designed to operate over a long period of time with little or no maintenance. If the pump
gets noisy, the filter basked and impeller need to be cleaned.
7. Warranty
Should any defect in materials or workmanship be found within twelve months of the date of purchase
AB Aqua Medic undertakes to repair, or at our option replace, the defective part free of charge –
always provided the product has been installed correctly, is used for the purpose that was intended
by us, is used in accordance with the operating instructions and is returned to us carriage paid. Proof
of Purchase is required by presentation of the original invoice or receipt indicating the dealer's name,
the model number and date of purchase, or a Guarantee Card if appropriate. This warranty may not
apply if any model or production number has been altered, deleted or removed, unauthorised persons
or organisations have executed repairs, modifications or alterations, or damage is caused by
accident, misuse or neglect. We regret we are unable to accept any liability for any consequential
loss. Please note that the product is not defective under the terms of this Warranty where the
product, or any of its component parts, was not originally designed and / or manufactured for the
market in which it is used. These statements do not affect your statutory rights as a customer.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
10
- Technical changes reserved - 05/2014