Troubleshooting; Troubleshooting Guide - Kohler K-1030-H2 Guia De Instalacion

Clean Up After Installation (cont.)
Remove stubborn stains and paint from the tower surfaces with turpentine or paint thinner. Remove
dried plaster by carefully scraping with a dull-edged piece of wood. Do not use metal scrapers, wire
brushes or other metal tools.
Remove residual plaster by applying a powder-type detergent to a clean, damp towel to provide
mild abrasive action.

31. Troubleshooting

Troubleshooting Guide

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified
electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Symptoms
1. Unit does not start or stop.
2. Water flow surges.
3. Motor starts, all bodyjets are
not functioning.
4. Unit stops automatically before
18 minutes.
5. Unit does not stop
automatically after 22 minutes.
1032120-2-C
Probable Causes
A. No power to
pump/receptacle/keypad.
B. Harness is blocked.
C. Keypad disconnected from
pump/control box.
D. Keypad doesn't work.
E. Not enough water in footbath
basin.
F. Motor/pump assembly does
not work.
G. Control does not work.
A. Not enough water in footbath
basin.
B. Suction is blocked.
C. Harness is blocked.
A. Bodyjet is blocked.
B. Bodyjet wiring loose or
damaged.
C. Not enough water in footbath
basin (pump cavitates).
D. Keypad does not work.
E. Control does not work.
A. GFCI or ELCB has tripped.
B. Motor overheated and
protection device activated.
A. Timer mechanism accidentally
deactivated.
24
Recommended Action
A. Set/Reset GFCI or ELCB.
Check wiring. Refer to
installer/dealer.
B. Remove blockage.
C. Reconnect keypad and/or
wiring harness.
D. Replace keypad. Refer to
installer/dealer.
E. Fill basin 3" (7.6 cm) over top
of suction cover.
F. Replace motor/pump
assembly. Refer to
installer/dealer.
G. Replace control. Refer to
installer/dealer.
A. Fill basin 3" (7.6 cm) over top
of suction cover.
B. Remove obstruction.
C. Remove blockage. Confirm
constant pipe pitch between
tower and pump.
A. Remove blockage.
B. Identify source of fault and
correct or replace wiring. Refer
to installer/dealer.
C. Fill basin 3" (7.6 cm) over top
of suction cover.
D. Replace keypad. Refer to
installer/dealer.
E. Replace control. Refer to
installer/dealer.
A. Set/Reset GFCI or ELCB.
B. Check for restricted air space
around pump box, motor vent
blockage, suction/harness
blockage. Correct and allow
motor to cool.
A. See service manual. Refer to
installer/dealer.
Kohler Co.