Dentsply Sirona Calamus Dual A1300 Manual Del Usuario página 131

STEP-BY-STEP INSTRUCTIONS
6. Pack: Install plugger into Pack hand piece: Push plugger into hand
piece tip and slowly rotate it until it keys in with hand piece tip. Push
plugger in fully.
7. Flow: Remove a cartridge from blister pack and install cartridge into
Flow hand piece: Unscrew and remove the cartridge nut from the hand
piece. Insert a cartridge into the hand piece, needle facing outward.
Slip cartridge nut over needle and screw cap on clockwise lightly - do
not tighten.
Note
Take care when replacing a cartridge during a procedure, the hand piece
cartridge nut and the expended cartridge may be hot to the touch.
Note
Allow cartridge to cool before removing. If the cartridge does not fit
completely into the hand piece, press the Power switch on the front of the
console to the 'ON' position and press the Return button on the console.
The plunger must be in its retracted position to accept the cartridge.
8. Turn the unit to the 'OFF' position before replacing a cartridge.
9. Gently place the heat shield over the cannula and hand piece as
necessary. Then turn the heat shield to make the flow indicator visible.
BENCALDDFUWEB / Rev.04 / 02-2019 (Old ZF 1902103.EN)
Fig. 3 - Flow hand piece with heat shield
11/40