Operation; Frequency Connections; Communications Port Connections; Measure Hz Or Count Pulses - GE Druck DPI 841 Manual De Usuario

Operation

This section gives examples of how to connect and use the
instrument. Before you start:
• Read and understand the "Safety" section.
• Do not use a damaged instrument.
Operation - Frequency connections
To prevent instrument errors, make sure that the
frequency connections (A1-item [10]) are correct.
Operation - Communications port connections
Use the communications port (A1 - item [9]) to attach an
IDOS Universal Measurement Module (UMM).
When you attach the cable from a UMM (Figure 7/8), the
instrument automatically changes the menus to give you
all the applicable options (Table 2/3).
Operation - Measure Hz or count pulses
To measure Hz or count pulses:
1. Connect the instrument (Figure 1) and, if necessary,
adjust the Set Up (Table 1).
2. Select a Hz or Pulses input task from Select Task
(Table 2/3) and, if necessary, adjust the Settings
(Table 4).
3. For Pulses, use Start/Stop (■ ■) to start and stop the
count. The display shows the time (hh:mm:ss) since you
started the count.
Figure 1: Example configuration - To measure Hz
or count Pulses
6
- [EN] English
Pulses
Settings Start
a) Hz b) Pulses
Operation - Change the output values
When the output operation is set up (Table 5), use one of
these procedures to change the output values:
Table 7: Procedures to change the output
Output
,
,
Pulses
Example procedure ("Nudge" output):
Display:
Hz output
Sk1 = Edit
Sk2 = Settings
Display:
Hz output
Settings
Procedure
Select Edit (■ ■) and/or use the ▲ ▼ buttons.
See the example below.
Select Start/Stop (■ ■) or use the ▲ ▼ buttons
to make the step changes manually.
Select Start/Stop (■ ■).
1 Edit 2
■ ■ ■ ■
5 6
▲ ▲
1.010 1.020
▼ ▼
Increment = 0.010
(Table 5)
3 Edit 4
▲
+01.000
▼
K395 Issue 3