Light Kit Assembly; Testing Your Fan - Craftmade TRE54ESP Guia De Instalacion

10. Light Kit Assembly.

Remove 3 screws from switch housing plate on
underside of motor housing.
Connect male plug from switch housing plate
to female plug from switch housing. Make sure
plugs connect tightly.
Carefully arrange wiring in switch housing and
align holes in switch housing with holes in
switch housing plate. Re-insert screws that
were previously removed. Tighten all 3 screws
with Phillips screwdriver.
Install 3 candelabra base 60-watt max. bulbs
(included).
Important: When replacing bulbs, please allow
bulbs to cool down before touching.

11. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall
switch (if applicable). Test fan speeds with the pull
chain on the switch housing. Start at the OFF position
(no blade movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull will
set the fan to LOW. Fourth pull will re-set the fan to
OFF setting. Test lights with the pull chain in the
middle. If fan and/or lights do (does) not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- DOWN position in summer (diagram 1)
- UP position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to function.
If the reverse switch is set in the middle position
(diagram 3), fan will not operate.
Pull chain extensions supplied or custom pull chain
extensions (sold separately) may be attached to the
ends of the pull chains.
switch
housing
plate
switch housing
bulb
diagram 1
page 8
motor housing
male plug
female plug
reverse
switch
pull chain
extension
light pull chain
extension
diagram 2 diagram 3