Starting Instructions - Movement Treadmill R4i Manual De Instrucciones

OPERATIONAL INSTRUCTION
SECURITY BUTTON
If the emergency clip is not attached to the belt, it will enter the safety lock mode. The
treadmill will emit an audible alarm and the display will show "E7". For the belt to exit the
safety lock mode, insert the clip into the electronics module.

STARTING INSTRUCTIONS

• Plug the power cord into the outlet. Turn the switch to the "ON" position. The screen
glows with an audible warning.
• Place the safety clip in the correct position, then the LCD screen will light up, and will
emit an audible alarm showing that the equipment enters the normal P0 mode.
• Press the "PROGRAM" BUTTON (BUTTON 12) to select the program P0-P36, U01, U02,
U03, FAT.
a) User program "P0". "MODE" button (BUTTON 9) to select the training mode. The user
can select the speed and training. Initial speed is 1.0km / h, and the slope is 0%.
Training mode 1: Count, Time, distance and calories. Press "+" "-" to modify the value.
Training mode 2: Countdown. The Time screen will pulse, press "+" "-" to modify the
value. The interval is 5-99 minutes. The starting time is 30:00.
Training mode 3: Distance countdown. The Distance screen pulses, press "+" "-" to
change the value. The range is 1.0-99.0 km. The initial distance is 1.0KM.
Training mode 4: Calorie countdown. The Calories screen pulsates, press "+" "-" to
modify the value. The range is 20-990CAL. The initial parameter is 50CAL.
b) "P1 — P36" Default program. For Countdown mode only. Under selection. The Tempo
screen pulses, press "+" "-" to select. The interval is 5-99 minutes. The pre-set time is
30:00. Press the "MODE" BUTTON to return to the initial parameter
c) FAT: Body fat tests, in FAT mode, the equipment must be in a stopped state.
Press "START" (BUTTON 8) after configuring the training mode, the screen displays 5
seconds of countdown, accompanied by five audible alarms, after the countdown, the
equipment starts smoothly. The treadmill gradually enters the pre-determined mode by
the user.
a) During the race, press the "+", "-" BUTTON (KEYS 5 and 6) or the "SPEED SHORTCUT"
BUTTON (BUTTON 4) to adjust the desired speed.
b) For P1 — P36, the speed and incline are divided into 10 segments. Each segment has
the same time. The speed after selection will be available in the current segment. When
running to the next segment, the treadmill will beep 3 times. When 10 segments are
finished, the engine will stop with a long audible alarm.
c) Press the "START" BUTTON (BUTTON 8) when running, it will pause. Press the "START"
BUTTON (BUTTON 8) again and it will work again and the data on the display will
continue normally.
28