Dremel 670 Traducción De Las Instrucciones Originales página 12

2 = Coupling
3 = Rip Crosscut Blade
4 = Screw
Maximum Capacities:
Blade - 31.8 mm (1-1/4")
Arbor Hole - 9.22 mm (.363")
Depth at 90° - 6.35 mm (1/4")
MINI SAW ATTACHMENT INSTALLATION
It is extremely important to carefully read and follow the directions below to
assemble the Mini Saw Attachment to your rotary tool and ensure the tool
will function properly.
To properly attach the Mini Saw Attachment to the rotary tool, THREE items
must be removed from the tool: the housing cap, collet nut and collet.
1. Press the shaft lock button, unscrew and remove the collet nut.
2. Remove the collet.
3. Unscrew the housing cap from the tool.
If the collet nut and collet are not removed from the motor shaft, the tool will
not function properly.
4. Install the drive adapter on the motor shaft and tighten.
TO PREVENT DAMAGE TO TOOL, DO NOT OVER TIGHTEN
!
DRIVE ADAPTER. TIGHTEN THE DRIVE ADAPTER FINGER
TIGHT AND THEN TIGHTEN AN ADDITIONAL 1/3 TURN WITH THE
WRENCH. (Wrench is included with your rotary tool kit.)
5. Screw the attachment onto your rotary tool until the coupling is tight
against the housing. Hand tighten only. The attachment should be
oriented on your rotary tool so that the speed control switch on the tool
is easily accessible.
ASSEMBLY
8
12
6
7