Matrix INDOOR CYCLING LIVESTRONG S Serie Manual De Instrucciones página 27

Ocultar thumbs Ver también para INDOOR CYCLING LIVESTRONG S Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2. To maintain the easy adjustability of the
resistance system, the threads on the lower end
of the brake rod should be lubricated. First, turn the
resistance knob clockwise until it stops. Next, look
under the right or left side of the frame and locate
the brake rod, which has two lock nuts on its lower
end. Apply a small amount of synthetic grease
(white lithium grease) to the threads on the brake
rod above the two lock nuts. Then, turn the
resistance knob counter-clockwise until it stops.
3. Some parts of the LIVESTRONG S-Series Indoor
Cycle may become loose as a result of repeated
use. Check pedals, toe clips, and pedal straps, and
make sure that they are properly tightened. Next,
check all exposed screws, bolts, and nuts, and
make sure
that they are properly tightened. Finally, check the
saddle to make sure that it is not loose or damaged.
Please use Locktite on loose crank arm and pulley
screws.
4. The brake pad will become worn as a result of
repeated use. The LIVESTRONG S-Series Indoor
Cycle should not be used if the emergency brake sy-
stem is not working properly (see page 23)! Should
you feel that the resistance system's functions are
deficient, it is essential to fine-tune the resistance
system before the bike is used again! Please check
the setting of the brake system as follows: First turn
the resistance regulator on the brake system as far
as it will go to the left (minimum braking effect). If
the setting is correct, the brake pads should be flush
with the flywheel and barely touching so that it's
possible to cycle with a hardly noticeable amount
of resistance. The brake pad can be adjusted using
a 10 mm wrench. Next, check the brake pad for
signs of wear. If the brake pad does show signs of
excessive wear, thoroughly soak the brake pad
with lubricant spray using the 2 lubrication holes
(B), and then wipe the excess off.
Version 1.1 2010 SBLS Copyright by Indoorcycling Group GmbH 2010 | www.indoorcycling.com
PREVENTATIVE MAINTENANCE
2
5
3
4
B
ENG 27
Tabla de contenido
loading

Este manual también es adecuado para:

2010 sb ls

Tabla de contenido