Power supply
Power consumption
Troubleshooting
Device does not work
Device no longer func
tions after a longer period
out of service or stops
during operation
(Overheating LED lights
up red).
Material jams
Paper Shredder CC 310.4 / MC 306.2
CC 310.4
220 - 240 V, 50 Hz,
1.3 A
max. 280 W
Is the power plug con
nected properly in the
power socket?
Is the material not drawn
in automatically or does
the cutting mechanism
not start up?
Has the permissible
operating cycle been
exceed?
Has the maximum
capacity of the infeed
been exceed?
Was the paper drawn
into the infeed straight?
Gi
Appendix
MC 306.2
220 - 240 V, 50 Hz,
1.2 A
max. 210 W
Insert the power plug in
a properly installed pow
er socket.
Feed the material in so
that the sensor, posi
tioned in the centre of
the infeed, detects the
material.
Disconnect the power
plug from the power
socket and allow the
motor to cool down.
Pay attention to the per
missible operating cy
cle (refer to Technical
Data).
Pay attention to the max
imum capacity of the
infeed (refer to Technical
Data).
Clear the material jam
(refer to Reverse Run
ning and Clearing Resid
ual Material)
Ensure the material is
straight when fed into the
infeed.
Clear the material jam
(refer to Reverse Run
ning and Clearing Resid
ual Material)
19