Lighting Instructions - Master Forge DGY784CP Manual Del Usuario

OPERATION INSTRUCTIONS

LIGHTING INSTRUCTIONS

CAUTION: If the flame extinguishes accidentally during ignition or operation,
immediately TURN OFF the cylinder valve and then TURN OFF the control knob.
Igniter Lighting System
1. Check all connections for leaks using the "soap water" test as explained on page 14
for "checking for leaks."
2. Open the smoker cabinet bottom door. Always keep the door open during lighting.
3. Check for any blockage to the venturi tube or burner, damper setting, ventilation setting.
Remove any foreign objects or matter.
4. Be sure the burner control knob is in the
"OFF" position.
5. Open the LP cylinder valve by turning
counterclockwise
6. Push igniter on the control unit down 1 to 2
seconds then push and turn control knob to
"HIGH," while still holding the ignitor button
down. At this point the burner should ignite.
7. If ignition does not take place within 5 seconds, immediately turn the control knob to OFF.
Wait 5 minutes and repeat above steps 6 and 7.
8. If burner still fails to light, try match lighting using the instructions on page 17.
9. Once the burner is lit, close the bottom door to allow heat to accumulate. The smoke stack
on the top of the smoker can be adjusted to the desired setting to allow proper ventilation
and combustion. NEVER CLOSE THE SMOKE STACK COMPLETELY.
Warning: Always light your smoker with the bottom door open.
.
HIGH
LOW
15
IGNITER