Setting The Operating Temperature; Indicator Lights - Beko FNE 1000 Manual Del Usuario

en
Setting the operating
temperature
(Fig. 2)
The operating temperature is regulated by the
temperature control.
Warm
1 2
1 = Lowest cooling setting (Warmest setting)
MAX. = Highest cooling setting (Coldest
setting)
Please choose the setting according to the
desired temperature.
The interior temperature also depends on
ambient temperature, the frequency with which
the door is opened and the amount of foods
kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended to close
the door again as soon as possible after use.
The normal storage temperature of your
appliance should be -18 °C (0 °F). Lower
temperatures can be obtained by adjusting
the thermostat knob towards Position MAX.
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.
Cold
3 4 MAX.

Indicator lights

There are three coloured indicator lights located
on the front of the appliance which shows the
operating mode of the freezer. (Fig. 2)
Green Indicator (1) Illuminates when the
appliance is connected to the mains and will
glow as long as electricity is available.
Amber Indicator (2) This indicator will glow
when the fast freeze switch (4) is on and will
continue to glow until the fast freeze switch is
turned off. The compressor will run
continuously while fast freeze switch is on.
Fast freeze operation is for freezing fresh food.
Red Indicator (3) Illuminates:
a) If the pre-set temperature can not be
maintained.
b) If excessive amounts of fresh food are
placed inside.
c) If the appliance door is left open accidentally.
IMPORTANT:
When you press the fast freeze switch, there
may be a short delay before the compressor
starts to operate. This is normal and does not
indicate a compressor fault.
4
en