External Spo Probe Connection - Gima OXY-10 Guía De Uso

27
"Pulse beep": Pulse beep button. When SpO
the pitch tone changes accordingly.
"Save, exit menu": long time pressing this item to store and exit from
the setup menu then enter the display screen.
"Restore default": Restore default setting. Refer to Figure 5 for each default
value.
On setup menu screen:
1. Short time press Display Key to choose the setting item;
2. Longtime press Display Key to active the setting item, then short time
press it to modify the setting parameter;
3. Next, longtime press Display Key to confirm the modification and exit from
this setting item.
4. At last, move the setting item to "Save, exit menu", and long time pressing
Display Key to store the modification and exit from the setup menu.
3.4 External SpO
1. Connect the external SpO
in the following way. Make sure the side with "Arrow" faces upwards.
Figure 6 Probe Connection
Note: when the external SpO
clip sensor will be disabled. The measurement is detected from the
external SpO probe.
2
2. The finger should be put in SpO
3. The oximeter will power on automatically 2 seconds later, then display
software version number.
4. Other operation is similar to chapter 3.1 directly measurement.
Probe Connection
2
probe to SpO
2
probe is connected well, the built-in finger
2
probe properly and correctly.
2
ENGLISH
value (90~99) changes,
2
sensor connector
2