Working Environment; Probe Connection - Gima OXY-100 Manual De Uso Y Mantenimiento

ENGLISH
24

1.6 Working Environment

Operating temperature: 5~40°C
Operating humidity: 30~80%
Atmospheric pressure: 70kPa~106kPa
2 Installation of Battery and Holder
Open the rear panel with coin or an ordinary flat
screwdriver, as shown in Figure 2-1.
According to the polarity mark, insert three AA
Figure 2-1
batteries into battery house, as shown in Figure
2-2.
Close the battery cover and lock it.
Fixing Holder, as shown in figure 2-3.
3 SpO

Probe Connection

2
Connect the SpO probe to the connector
2
labeled "SpO " at the right side of the Oximeter.
2
After starting up the Oximeter, insert one finger
(index finger, middle finger or ring finger with
proper nail length) into the probe according to
the demonstration shown in the following figure.
Figure 2-2
Figure 3-1 Demonstration for Using SpO
Figure 2-3 Fixing Holder
2
probe (finger clip)