Connecting Hose To Heater; Connecting Regulator To Gas Supply - L.B.White Premier TS350DF Manual Del Usuario E Instrucciones

Connecting Hose to
Heater
1. Thread swivel onto connector at gas inlet of heater.
See Fig. 1. Tighten securely.
2. The hose may be coiled up and hung on the hose
hanger, with the regulator stored within the regulator
storage bracket.
FIG. 1
Connecting Regulator to
Gas Supply
WHEN USING PROPANE GAS:
1. Lift the tank's cover.
2. Assemble the gas componets as shown, depending
on heater type. Tighten connections securely. See
Fig. 2.
FIG. 2
3/4 X 1/4 Bushing
SWIVEL
Tank Valve
1/4 in.
POL
NPT
Pigtail Connector
Owner's Manual • Premier 350
Premier Ductable Heaters
3. Form the pigtail connector to ensure the regulator
will be supported by the tank, and the tank valve
cover will protect the regulator from weather
conditions.
4. Thread connector's POL fi tting counter-clockwise
into the tank valve. Tighten securely. See Fig. 2.
5. Open the tank valve.
6. Check all connections with an approved leak
detector. Close the tank's cover.
7. When storing or transporting the heater, ensure the
connector's fi tting is protected from damage and
dirt entry.
WHEN USING NATURAL GAS:
--- The regulator only should be used if the gas supply
pressure to the heater is above the maximum inlet
pressure stated on the heater's dataplate.
--- Connect the regulator as supplied with the heater
to the natural gas supply line, using the appropri-
ate connections. (DO NOT USE THE POL/PIGTAIL
FOR NATURAL GAS INSTALLATIONS)
--- Gas supply pressure to the regulator
must be a minimum of 2 PSI/13.7 kPa.
11