Connecting The Hob To The Mains Power Supply - CORBERO CCIG321 Manual De Instrucciones

9.3 After installing the hob, make sure that
• The power supply cable is not accessible through cupboard doors or drawers.
• There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
• The isolating switch is easily accessible by the customer.
9.4 Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the hob
9.5 Adjusting the bracket position
Fix the hob on the work surface by screw 2 brackets on the bottom of hob (see picture) after
installation. Adjust the bracket position to suit for different table top thickness.
9.6 Cautions
The hob must be installed by qualified personnel or technicians. We have professionals
1.
at your service. Please never conduct the operation by yourself.
The hob will not be installed directly above a dishwasher, fridge, freezer, washing
2.
machine or clothes dryer, as the humidity may damage the hob electronics
The hotplate shall be installed such that better heat radiation can be ensured to
3.
enhance its reliability.
The wall and induced heating zone above the table surface shall withstand heat.
4.
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
5.
A steam cleaner is not to be used.
6.

9.7 Connecting the hob to the mains power supply

This hob must be connected to the mains power supply only by a suitably qualified
person. Before connecting the hob to the mains power supply, check that:
The domestic wiring system is suitable for the power drawn by the hob.
1.
The voltage corresponds to the value given in the rating plate
2.
The power supply cable sections can withstand the load specified on the rating plate.
3.
To connect the hob to the mains power supply, do not use adapters, reducers, or
branching devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 75˚C at any point.