Finish Cooking - CORBERO CCIG321 Manual De Instrucciones

Select power level by touching the MINUS (2) or PLUS key
(3).
If you don't choose a heat setting within 1 minute, the
•
hob will automatically switch off. You will need to start
again at step 1.
You can modify the heat setting at any time during
•
cooking.
If the display flashes
This means that:
you have not placed a pan on the correct cooking zone or,
•
the pan you're using is not suitable for induction cooking or,
•
the pan is too small or not properly centered on the cooking zone.
•
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 2 minutes if no suitable pan is placed on it.
3.3.2

Finish cooking

Touching the heating zone selection control that you wish to
switch off.
Turn the cooking zone off by touching the MINUS (2) to "0".
Make sure the display shows "0".
Turn the whole cooktop off by touching the ON/OFF control.
Beware of hot surfaces
H will show which cooking zone is hot to touch. It will disappear
when the surface has cooled down to a safe temperature. It can
also be used as an energy saving function if you want to heat
further pans, use the hotplate that is still hot.
3.3.3 Using the Boost function (for induction hob)
Select the zone with Booster, then touching the BOOST key
(7), the zone indicator shows "P" and the power reach Max.
alternately with the heat setting (for induction hob)
Activate the boost function
Cancel the Boost function