Canopy Assembly; Blade Assembly. Pgs - Craftmade DANE Guia De Instalacion

8. Canopy Assembly.

Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket
align with slotted holes in canopy, and then lower
canopy and partially loosen these 2 screws.
Remove the other 2 screws and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist canopy
to lock. Re-insert the other 2 screws and star
washers and secure all screws with Phillips
screwdriver.
Align arrow on canopy ring with the arrow on the
canopy. Next, raise the canopy ring over the
canopy until it is even with the top of the canopy.
Make sure the canopy and the canopy ring fit
securely.
9. Blade Assembly.
Locate motor screws and lock washers in
hardware pack. Align pin and 2 holes in blade
arm with corresponding holes in motor plate.
Partially insert 2 motor screws (and lock
washers) and then tighten both scews securely.
Repeat with remaining blade arms.
Locate 9 blade attachment screws and fiber
washers in hardware packs. Align blade holes
with posts on blade arm. Insert 3 blade
attachment screws (along with fiber washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat for
the remaining blades.
["Blade Assembly" continued on next page.]
slotted
hole
arrow
arrow
motor plate
pin
blade arm
page 7
hanging bracket
canopy
canopy
canopy
ring
motor screws and
lock washers
blade arm
blade attachment
screws and fiber washers
blade
post