Functional Description - Porter Cable PCEG011 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

FIGURE A
1. Slider switch
2. Cord
3. Tool free guard
4. Body grip
5. Auxiliary handle (3 positions)
6. Spindle lock button
7. Wrench
count per inch
................. Read instruction manual
before use
.....................Use proper eye protection
.....................Use proper hearing protection
......................... Use proper respiratory protection
ASSEMBLY
WARNING:
To prevent accidental
operation, turn off and unplug tool
before performing the following
operations. Failure to do this could result in
serious personal injury.
ATTACHING THE AUXILIARY
HANDLE
WARNING:
This handle
SHOULD BE USED AT ALL TIMES to
maintain complete control of the tool. Always
make sure the handle is securely attached.
A three position auxiliary handle (5) is
furnished with your grinder and can be
screwed into either side of the grinder
housing as well as into the top.
ACCESSORIES
It is important to choose the correct
guards, backing pads and flanges to use
with grinder accessories (see Accessories
Chart in this manual.)
CAUTION:
Accessories must be rated
for at least the speed recom mended on the
tool warning label. Wheels and other
accessories running over their rated
accessory speed may fly apart and cause
injury. Threaded accessories must have a 5/8
inch-11 hub. Every unthreaded accessory
must have a 7/8 inch (22mm) arbor hole. If it
does not, it may have been designed for a
6
7
7
4
5
3
circular saw. Use only the accessories shown
on pages 10 and 11 of this manual.
Accessory ratings must always be above tool
speed as shown on tool nameplate.
MOUNTING GUARD
MOUNTING AND REMOVING GUARD
Turn off and unplug tool before making
any adjustments or removing or installing
attachments or accessories. Guards must
be used with all grinding wheels, sanding
flap discs, wire brushes, cut-off wheels and
wire wheels. The tool may be used without
a guard only when sanding with conventional
sanding discs. Porter Cable model PCEG011
is provided with a guard intended for use
with depressed center wheels (Type 27)
and hubbed grinding wheels (Type 27). The
same guard is designed for use with sanding
flap discs (Type 27) and wire cup brushes.
Grinding with wheels other than Type 27
require different accessory guards. A Type
1/41 guard is not provided.
NOTE:
Porter Cable model PCEG011
is provided with a Type 27 guard only.
A Type 1/41 guard for use with cut off
wheels is available from a PORTER-CABLE
Factory Service Center or a PORTER-CABLE
Authorized Warranty Service Center. Please
visit our Web Site www.portercable.com for
the name of the nearest supplier.
Type 27 guards attach and are removed
as described in Figures B and C.
FIGURE B
1. ATTACHING - Open the guard latch (8),
and align the lugs on the guard (3) with
the slots on the gear case cover.
2. Push the guard down until the guard
lugs engage and rotate freely in the
groove on the gear case hub.
3. With the guard latch open, rotate the guard
2
1