Functional Description; Attaching The Auxiliary Handle - Porter Cable PCE810 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

FIGURE A
1. Slider switch
2. Cord
3. Tool free guard
4. Body grip
5. Auxiliary handle (3 positions)
6. Spindle lock button
7. Wrench
ASSEMBLY
WARNING:
operation, turn off and unplug tool
before performing the following
operations. Failure to do this could result in
serious personal injury.

ATTACHING THE AUXILIARY HANDLE

WARNING:
SHOULD BE USED AT ALL TIMES to
maintain complete control of the tool. Always
make sure the handle is securely attached.
A three position auxiliary handle (5) is
furnished with your grinder and can be
screwed into either side of the grinder
housing as well as into the top.
ACCESSORIES
It is important to choose the correct
guards, backing pads and flanges to use
with grinder accessories.
CAUTION:
Accessories must be rated
for at least the speed recom mended on the
tool warning label. Wheels and other
accessories running over their rated
accessory speed may fly apart and cause
injury. Threaded accessories must have a
5/8 inch-11 hub. Every unthreaded
accessory must have a 7/8 inch (22mm)
arbor hole. If it does not, it may have been
designed for a circular saw. Use only the
accessories shown on pages 10 and 11 of
this manual. Accessory ratings must always
be above tool speed as shown on tool
nameplate.
MOUNTING GUARD
MOUNTING AND REMOVING GUARD
Turn off and unplug tool before making
any adjustments or removing or installing
To prevent accidental
This handle
6
3
attachments or accessories. Guards must
be used with all grinding wheels, sanding
flap discs, wire brushes, cut-off wheels and
wire wheels. The tool may be used without
a guard only when sanding with conventional
sanding discs. Porter Cable model PCE810
is provided with a guard intended for use
with depressed center wheels (Type 27) and
hubbed grinding wheels (Type 27). The same
guard is designed for use with sanding flap
discs (Type 27 and 29) and wire cup brushes.
Grinding and cutting with wheels other than
Type 27 and 29 require different accessory
guards. A Type 1 guard is not provided.
NOTE:
is provided with a Type 27 guard only. A
Type 1 guard for use with cut off wheels is
available from a PORTER-CABLE Factory
Service Center or a PORTER-CABLE
Authorized Warranty Service Center. Please
visit our Web Site www.portercable.com for
the name of the nearest supplier.
Both Type 27 and Type 1 guards attach
and are removed in the same way as
described in figures B and C.
FIGURE B
1. ATTACHING - Open the guard latch (8),
and align the lugs on the guard (3) with
the slots on the gear case cover.
2. Push the guard down until the guard
lugs engage and rotate freely in the
groove on the gear case hub.
3. With the guard latch open, rotate the guard
(3) into the desired working position. The
guard body should be positioned between
the spindle and the operator to provide
maximum operator protection.
4. Figure C - Close the guard latch to secure
the guard on the gear case. You should not
be able to rotate the guard by hand when
7
4
1
5
Porter Cable model PCE810
2
7