Porter Cable PCEG011 Manual De Instrucciones página 14

the tool to rest on the work surface
without moving, or moving the tool in
a circular motion causes burning and
swirling marks on the work surface.
6. Remove the tool from the work surface
before turning the tool off. Allow the tool
to stop rotating before setting it down.
Use extra care when working over an
edge, as a sudden sharp movement of
grinder may be experienced.
N
MOUNTING AND USING CUTTING
(TYPE 1/41) WHEELS
Cutting wheels include diamond wheels
and abrasive discs. Abrasive cutting wheels
for metal and concrete use are available.
Diamond blades for concrete cutting can
also be used.
NOTE
: A closed, 2-sided Type 1/41
cutting wheel guard is sold separately and
is re quired when using cutting wheels.
Fail ure to use proper flange and guard
can re sult in injury resulting from wheel
breakage and wheel contact.
MOUNTING CLOSED (TYPE 1/41)
GUARD
WARNING:
To prevent accidental
operation, turn off and unplug tool
before performing the following
operations. Failure to do this could result in
serious personal injury.
1. Figure O - Align the three lugs on the
guard (3) with the three slots on the
hub. This will align the lugs with slots on
the gear case cover.
2. Push the guard down until the guard
lug engages in the groove on the gear
case hub.
3. Rotate guard (3) counterclockwise
to lock it into place. The guard body
should be positioned between the
spindle and the operator to provide
maximum operator protection.
4. Tighten the guard latch screw to secure
the guard on the gear case cover. You
should be unable to rotate the guard
5. To remove the guard, loosen the guard
O
5˚- 10˚
MOUNTING CUTTING WHEELS
WARNING:
operation, turn off and unplug tool
before performing the following
operations. Failure to do this could result in
serious personal injury.
Matching diameter backing flange and
threaded clamp nut (included with tool)
must be used for cutting wheels.
1. Place the unthreaded backing flange
2. Place the wheel on the backing flange,
3. Install the threaded clamp nut with the
4. Depress the spindle lock button and
5. To remove the wheel, depress the
USING CUTTING WHEELS
Do not use edge grinding/cutting wheels for
surface grinding applications because these
wheels are not designed for side pressures
encountered with surface grinding. Wheel
breakage and injury may result.
1. Allow tool to reach full speed before
2. Apply minimum pressure to work
14
by hand. Do not operate grinder with a
loose guard.
latch screw. Then rotate the guard so
that the three lugs on the guard (3)
align with the three slots on the hub and
pull up on the guard.
1 2
To prevent accidental
on spindle with the raised section
(pilot) facing up. The raised section
(pilot) on the backing flange will be
against the wheel when the wheel is
installed.
centering the wheel on the raised
section (pilot).
raised section (pilot) facing away from
the wheel.
tighten clamp nut with included wrench.
spindle lock button and loosen the
threaded clamp nut with included wrench.
touching tool to work surface.
surface, allowing tool to operate at high
speed. Cutting rate is greatest when the
tool operates at high speed.
3