Troubleshooting; Maintenance / Cleaning - Porter Cable PCEG011 Manual De Instrucciones

Problem
• Unit will not start.
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the PorterCable Customer Care Center at (888) 848-5175.
3. Once a cut is begun and a notch is
established in the workpiece, do not
change the angle of the cut. Changing
the angle will cause the wheel to bend
and may cause wheel breakage.
4. Remove the tool from work surface
before turning tool off. Allow the tool to
stop rotating before setting it down.
MAINTENANCE
CLEANING
Blowing dust and grit out of the motor
housing using compressed air is a
necessary maintenance procedure.
Dust and grit from metal grinding often
accumulate on interior surfaces and could
create an electrical shock hazard if not
cleaned out.
• Always handle accessories with care
when mounting or removing.
• The best storage place for accessories is
one that is cool and dry away from direct
sunlight and excess heat or cold.
WARNING:
ALWAYS use safety
glasses. Everyday eyeglasses are NOT
safety glasses. Also use face or dust mask
if cutting operation is dusty. ALWAYS
WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
Use only mild soap and a damp cloth to clean
the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.

TROUBLESHOOTING

Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
15
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Porter Cable
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Porter
Cable service center or
authorized servicer.)
• Have cord or switch replaced
at a Porter Cable Service
Center or Authorized Servicer
LUBRICATION
Porter Cable tools are properly lubricated
at the factory and are ready for use. Tools
should be lubricated regularly every year
depending on usage. (Tools used on heavy
duty jobs and tools exposed to heat may
require more frequent lubrication.) This
lubrication should be attempted only by
trained power tool repairperson's such as
those at Porter Cable service centers or in
other qualified service personnel.
REPLACEMENT PARTS
Use only identical replacement parts. For a
parts list or to order parts, visit our service
website at www.portercableservicenet.com.
You can also order parts from your nearest
Porter Cable Factory Service Center or
Porter Cable Authorized Warranty Service
Center. Or, you can call our Customer Care
Center at (888) 848-5175.
SERVICE AND REPAIRS
All quality tools will eventually require
servicing and/or replacement of parts.
For information about PORTER-CABLE,
its factory service centers or authorized
warranty service centers, visit our website
at www.portercable.com or call our
Customer Care Center at (888) 848-5175.
All repairs made by our service centers are
fully guaranteed against defective material
and workmanship. We cannot guarantee
repairs made or attempted by others.
You can also write to us for information at
PORTER-CABLE, 4825 Highway 45 North,