Maruyama BC360HT Manual Del Propietario - Operador página 6

THROTTLE CABLE WIRING
The cable lug must be inserted into and through the cable
adjuster sleeve held by the bracket on top of the carburetor.
Make sure the end of the cable housing is seated positively in
the sleeve. The cable lug fi ts into the slotted fi tting as shown.
A HOLE IS PROVIDED FOR THE LUG AT ONE END OF THE
SLOT.
Operate the throttle trigger a few times to make sure that it
works correctly.
Adjust the cable adjuster sleeve so the cable position keep
1-2mm play between cable lug and slotted fi ttings when the
throttle trigger is fully depressed. When the throttle cable is
adjusted correctly, tighten the lock nut.
Clamp the throttle cable assembly with two bands as shown.
[BC360HE, BC420HE]
Caution! : This swivel stopper is exclusively for fi xing the
handle in transport. Do not engage the swivel stopper while
operating the brushcutter.
In transport and storage:
Tighten the wing nut, confi rm the handle is fi xed by the swivel
stopper.
In operation:
Before start operation of the brushcutter, disengage the swivel
stopper. Loosen the wing nut, confi rm the handle becomes
free to turn around.
＿ US-4 ＿
Throttle Cable Housing
Cable Adjuster Sleeve
Throttle Cable
Slotted Fitting
Lock Nut
Carburetor
Bracket
Recessed Hole
1-2mm Play
Band (2)
Throttle cable
assembly
Wing Nut
Cable Lug
Loosen
Tighten