Wall Control Operation; Remote Control Operation; Testing Your Fan - Craftmade DE52CH4 Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

11. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
FAN OFF button - turns fan OFF
REV button - used to REVERSE blade direction (fan must be set
on low before reversing blade direction)
LIGHT button - (for use with optional light kit) turns light
ON/OFF when pressed once; dims light when pressed and held
down.

12. Remote Control Operation.

HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
button - turns fan OFF
button - used to REVERSE blade direction (fan
must be turned low before reversing blade direction)
button - pushing
ON/OFF; pressing
button and holding it down for
more than 0.7 seconds converts it into a dimmer

13. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Locate ON/OFF slider switch on wall control
and set to the ON position. Test light and dimmer
function and then test fan speeds. Next, locate remote
control. Start with the lights OFF and test the light
ON/OFF function by pressing on the
dimmer function by pressing the
it down for more than 2 seconds. Test fan speeds with
the different fan speed buttons. If the remote control
operates all of the functions of the fan, battery has been
installed correctly. If the wall and/or remote controls do
(does) not operate all of the fan functions, refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Fan must be on LOW before setting the fan to reverse
direction. Use REV button to recirculate air depending on
the season.
NOTE: If the remote control interferes with other
appliances, change code switches on the transmitter
(AND wall control) to another code. If you do change the
code, turn power off first, remove the battery cover, and,
after setting the new code, go back to the instructions in
the last paragraph of Section 7 (page 7).
button turns light
button. Test the
button and holding
page 10

Capítulos

Tabla de contenido
loading

Tabla de contenido