Wiring. Pgs; Important; Automated Learning Process./ Activating Code. Pgs - Craftmade DE52CH4 Guia De Instalacion

6. Wiring. (cont).
It is advisable to check that the wiring has
been done correctly before proceeding.
Connect WHITE wire from motor assembly to
WHITE wire from light kit fitter. Connect
BLACK (or BLUE) wire from motor assembly to
BLACK wire from light kit fitter. Make sure that
molex connections are secure.
Install the bulb provided.
Tip: Do not touch glass portion of bulb with
fingers or hands. Oil from skin can cause bulb to
overheat and go out prematurely. Use cardboard
box or foam wrapping bulb was packed with to
layer around glass portion of bulb.
IMPORTANT: Please allow bulb to cool down
before touching, keeping in mind not to touch
the bulb itself as described above (see "Tip").
Continue to "Automated Learning
Process/Activating Code" section below.
7. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not desired,
turn wall switch off to any other programmable receiver or
fan.
This remote control transmitter is equipped with 16 code
combinations to prevent possible interference from or to
other remote units such as garage door openers, car
alarms or security systems. If you find that your fan and
light go on and off without using your remote control,
simply change the combination code in your remote
control transmitter (and wall control). To set the code,
perform these steps:
Remove battery cover on back side of remote control
transmitter.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 for the transmitter. Use the same
number sequence used when wiring the wall control in
Section 6 (page 5).
Note: Since this fan comes with a halogen bulb, the
dimmer switch (labeled D and X) has been pre-set to the
"ON" position (D). If you do not wish to have dimming
capability, please move the switch to the "OFF" position
(X).
Install one 12-volt battery (included) in transmitter.
Re-attach battery cover on transmitter.
["Automated Learning Process/Activating Code"
continued on next page.]
receiver
dimmer
switch
page 6
molex connections
light kit fitter
JD E11 bulb
transmitter
code
(back)
switches
12V battery
battery
cover