Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall and/or handheld remote control can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
Restore electrical power and then, if using wall control,
set slider switch on wall control to the ON position.
Within 60 seconds of turning on the wall control, press
and hold the fan SET button on the wall control for
5 seconds (or until light blinks twice or fan blades begin
to turn).
Turn power off again for at least 5 seconds and then turn
power back on. Within 60 seconds of restoring the power,
press and hold the fan SET button on the handheld
remote control for 5 seconds or until light blinks twice.
Test the light and fan functions to confirm the learning
process is complete--see Section 14.
Select a faceplate (almond or white) and press firmly onto
front of wall control that was previously installed to the
outlet box on the wall. [Refer to diagram 1.]
Attach black faceplate to front of handheld remote
control; press down firmly. [Refer to diagram 2.]
12. Remote/Wall Control Operation.
handheld
remote control
2
III
IV
1
II
VI
I
4
Fan SPEED control buttons--1:
Fan OFF button--2:
REVERSE function button--3:
LIGHTING button--4:
ON/OFF slider switch--5:
IMPORTANT: The Automated Learning Process takes approximately 5 minutes to complete. Please leave the
fan "ON" for the duration of the 5-minute programming and do NOT use the remote control or
turn off the power during this time. The fan will cycle through ALL SIX (6) speeds in forward
and reverse and will then stop automatically after the learning process is complete.
IMPORTANT:
Handheld remote
control and wall
control must be
V
SYNCHRONIZED with
fan in order to
properly function.
Use to control the ceiling fan speed 1-6
Use to turn the fan off
Use to control fan direction
Use to control down-light and/or up-light (if applicable)
[Wall control only] Use to turn wall control ON or OFF
diagram 1
diagram 2
page 13
wall control
III
IV
II
V
I
VI
OFF
SET button
handheld
remote control
faceplate
IV
III
II
V
VI
I
SET button
wall control
2
III IV
1
II
V
I
VI
3
4
5
OFF
ON
faceplate
(almond
or white)
ON
(black)
OFF
ON
Tabla de contenido
