Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11. Remote/Wall Control Operation.
handheld
remote control
2
III
IV
1
II
I
4
Fan SPEED control buttons--1:
Fan OFF button--2:
REVERSE function button--3:
LIGHTING button--4:
ON/OFF slider switch--5:
IMPORTANT
: The Automated Learning Process takes approximately 5 minutes to complete. Please
leave the fan "ON" for the duration of the 5-minute programming and do NOT use the
remote control or turn off the power during this time.
The fan will cycle through ALL SIX (6) speeds in forward and reverse and will then stop
automatically after the learning process is complete.
12. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and wall switch (if applicable). Test
wall control (optional installation) by locating ON/OFF slider switch on
wall control, then set to the ON position. Test light and dimmer
function and then test fan speeds. Next, locate handheld remote
control. Test fan speeds with the different fan speed buttons (I - VI)
on handheld remote control. Test the light ON/OFF function by
pressing the
button; test the dimmer function by pressing
the
button and holding it down for 1 second. If the remote
control operates all of the functions of the fan, battery has been
installed correctly. If the wall and/or remote controls do (does) not
operate all of the fan functions, refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Fan must be on LOW before setting the fan in reverse. Use
to recirculate air depending on the season. A ceiling fan will allow you
to raise your thermostat setting in summer and lower your thermostat
setting in winter without feeling a difference in your comfort.
NOTE: If the wall control/handheld remote control interferes with
other appliances, activate a new code on the wall control/ handheld
remote control by turning the power off first. Go back to the
instructions for the SET button in Section 10 (page 9).
IMPORTANT: Handheld remote control and wall control must be
synchronized with fan in order to properly function.
IMPORTANT:
Handheld remote
control and wall
control must be
V
SYNCHRONIZED with
VI
fan in order to
properly function.
Use to control the ceiling fan speed 1-6
Use to turn the fan off
Use to control fan direction
Use to control down-light and up-light (if applicable)
[Wall control only] Use to turn wall control ON or OFF
button
page 10
wall control
2
III IV
1
II
V
VI
I
3
5
OFF
ON
III IV
II
V
I
VI
OFF
ON
III
IV
II
V
I
VI
4
Capítulos
Tabla de contenido
