10. Light Kit Assembly (Optional). (cont.)
Remove 1 screw from post on underside of fitter
plate and partially loosen the other 2 screws.
Connect WHITE wire from motor assembly to
WHITE wire from light kit fitter. Connect BLACK
(or BLUE) wire from motor assembly to BLACK
wire from light kit fitter. Make sure that molex
connections are secure.
Align slotted holes in light kit fitter with
loosened screws in fitter plate. Twist light kit
molex connections
fitter to lock. Re-insert screw that was previously
removed and tighten all 3 screws securely.
light kit fitter
Install one 75-watt halogen bulb, type JD E11
(included).
Tip: Do not touch glass portion of bulb with fingers
or hands. Oil from skin can cause bulb to overheat
JD E11 bulb
and go out prematurely. Use cardboard box or
foam wrapping bulb was packed with to layer
around glass portion of bulb.
Locate slots on glass shade and align with
dimples on light kit fitter. Push up gently on
glass shade and turn in a clockwise direction
until it no longer turns. Pull down gently on glass
shade to make certain that it is secure.
dimple
IMPORTANT: When replacing bulb, please allow
bulb and glass shade to cool down before
touching. Use 75-watt max. halogen bulb, type
JD E11, to replace the bulb, keeping in mind not
slot
to touch the bulb itself as described above (see
"Tip").
glass shade
page 9