DeWalt DWE6000 Manual De Instrucciones página 32

WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALL USERS AND BYSTANDERS MUST
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min .......... revolutions per minute
BPM ............. beats per minute
IPM ............... impacts per minute
SPM ............. strokes per minute
sfpm ............. surface feet
..................... per minute
.....................
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating
........................or direct
current
n o ....................no load
....................... speed
n ......................rated
........................speed
.....................earthing
terminal
.....................safety alert
symbol
30
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D WALT tools are factory tested; if this tool does not
E
operate, check power supply.
DESCRIPTION (Fig. 1, 2)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Quick release tabs
B. Depth adjustment ring
C. On/off switch
D. Spindle lock button
E. Spindle
F. Micro adjustment scale
G. Locking lever
H. Base
I. Subbase
J. Sub-base screws
K. Guide rail
L. Locking lever adjustment
screw
M. Collet
N. Collet nut
O. Motor unit
P. Guide slot
Q. Guide screw
R. Dust extraction adaptor
S. Dust exhaust port
T. Finger screws
U. Roller bearing guide