Canopy Assembly; Blade Assembly - Craftmade Ellington Metron Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed, and then
tighten both screws securely. Slide canopy cover
up to canopy, aligning rounded part of slotted
holes in canopy cover with screw heads in bottom
of canopy. Turn canopy cover to right (clockwise)
until it stops.

8. Blade Assembly.

Time Saver: Washers for blade screws
can be set on each blade screw prior to
installing blades.
Locate 12 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning
holes in blade with holes in blade plate
(located on the underside of the motor
housing)--refer to drawing at right. Insert
3 blade attachment screws (along with
washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
Note: Tighten blade attachment screws
twice a year.
screw
canopy
page 7
hanging bracket
screw
canopy cover
motor housing
blade
blade plate
blade attachment
screws and washers