Denon AVR-1604 Instrucciones De Operación página 19

After starting playback
[1] Adjusting the sound quality (tone)
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
BASS TREBLE
(Main unit)
2
With the name of the volume to be adjusted
selected, turn the SELECT knob to adjust the
level.
(Main unit)
• To increase the bass or treble: Turn the control
clockwise. (The bass or treble sound can be
increased to up to +12 dB in steps of 2 dB.)
• To decrease the bass or treble: Turn the
control counterclockwise. (The bass or treble
sound can be decreased to up to –12 dB in
steps of 2 dB.)
[2] Listening over headphones
1
Plug the headphones' plug into the jack.
PHONES
1
Connect the headphones to the PHONES
jack.
The speaker output is automatically turned
off when headphones are connected.
[3] Turning the sound off temporarily (muting)
1
Use this to turn off the audio output temporarily.
Press the MUTING button.
(Remote control unit)
Cancelling MUTING mode.
• Press the MUTING button again.
• Muting will also be cancelled when
MASTER VOL is adjusted up or down.
All manuals and user guides at all-guides.com
2 3
3
If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
The signals do not pass through
the bass and treble adjustment
circuits, so it provides higher
quality sound.
(Main unit)
NOTE:
To prevent hearing loss, do not raise the volume level
excessively when using headphones.
1
[4] Combining the currently playing sound with the desired image
1
Simulcast playback
Use this switch to monitor a video source other
than the audio source.
Press the VIDEO SELECT button repeatedly
until the desired source appears on the display.
1
(Remote control unit)
Cancelling simulcast playback.
• Select "SOURCE" using the video select
button.
• Switch the program source to the
component connected to the video input
jacks.
[5] Checking the currently playing program source, etc.
1
Front panel display
• Descriptions of the unit's operations are also
displayed on the front panel display. In
addition, the display can be switched to
check the unit's operating status while
playing a source by pressing the STATUS
button.
(Remote control unit)
2
Using the dimmer function
• Use this to change the brightness of the
display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing
the main unit's DIMMER button repeatedly.
BRIGHT
(Remote control unit)
1
1
2
MEDIUM DIM
OFF
ENGLISH
19