Denios GS 305 Manual Del Usuario página 14

Gas cylinder cabinet without base GS 305-B
(Also see overview Fig. of the cabinet (Assembly GS 305-B) p. 7 and parts list p. 11)
1. Align the location bars (52) and the centre support (9) at diagonal right angles as shown in Fig. 10 „securing
the base to the floor".
2. Secure the side frames (1) and the centre support (9) to secure them to the floor using screws (29) (see Fig.
2 „securing the base to the floor").
3. Screw the centre support (9) to the location bars (52) using sunken head screws (53, 56, 57).
4. Screw the two part front roof brace (4 and 6) together using round head screws (5 und 5.1) and screw them
the side frames using hexagonal screws (22, 23, 24), (see Fig. 5 „assembling the front roof brace element").
Place the roof (14) on top of the cage (ensure that it overhangs by approx. 500 mm at the front and 50 mm
at the back) and screw it to the front roof brace and the rear panel using drilling screws (15). Secure the U
channels (14.1 and 14.2) to the front edge of the roof using drilling screws(15).
5. Secure the bottom of the hinge (11) to the side frames using hexagonal screws (22, 23, 24), (see Fig. 6
„hinges").
6. Place the mortise lock (16) on door 2 and screw it in place using self-tapping screws (20). Put the profile half
cylinder (17) on the lock, then add on the protective plate (19), plastic plugs (21) and the door handle (18).
Secure the protective plate in place using sunken head screws (20) (see Fig. 7 „lock").
7. Secure the bolt (43) to door 3 using sunken head screws (20) (see Fig. 8 "wing door").
8. Assembling the doors: Hang door 3 on the container first, followed by door 2. Tap the steel pin (13) into the
top part of the hinge on door 2 and hang the door on the container. Tap the smaller pin (12) into the bottom
of the hinge. Align the door, adjust the screws in the hinges or, if necessary, push the side frames lightly.
9. Tighten all screws, if necessary.
10. Stick the following signs on a board (47) on the door, „smoking and open flame prohibited, and no access
to unauthorised personnel" (45 and 46).
11. If the gas cylinders are going to be stored without gas cylinder pallets, the gas cylinder holder (8) must be
secured to the rear panel using hexagonal screws (23, 24, 25) (see Fig. 9 gas cylinder holder). The support
for the gas cylinder holder (10) should be placed under the seam in the rear panel and screwed to the holder
(8) using hexagonal screws (23, 26). The securing chain (28) should be fastened to S hooks (27) pushed
through drill holes in the gas bottle holder and hung on the mesh side panels..
Gasflaschenschrank GS 305-B / GS 305
115861 / 11586
Seite 14 von 28 Seiten Ausgabe 06/2007