Tabla de contenido
1. Assembly & Use (cont.)
1.3 Lactina
Pump Kit Assembly & Use
®
Caution
• Wash hands with soap and water prior to handling your kit�
• Always inspect breastshields, connectors, valves, membranes
and tubing prior to use for cleanliness�
• Contact your healthcare professional or breastfeeding specialist if
you can express only minimal or no milk or if expression is painful�
See Supplemental Information section 5 for more information�
• Do not try and express with vacuum that is too high and
uncomfortable (painful)� The pain, along with potential breast and
nipple trauma may decrease milk output� See section 5 for more
information�
Wash hands with soap and water
prior to handling your kit.
Pump connector
2 Screw cylinder
3 Attach pump
tightly into Lactina
connector to
pump connector.
Lactina, and rotate
cylinder down into
position.
8
Cylinder
Piston
1 Slide the vacuum
regulator ring
onto cylinder.
Push handle end
of piston into
cylinder.
4 Slip piston into
pumping arm
cradle, and push
down until snug.
5 Securely attach
6 Snap membranes
onto yellow valves
breastshields to
connectors.
until membranes
lie flat.
8 Screw collection
9 Insert pale yellow
containers onto
round ends
connector bottoms.
of tubing into
openings in back
of connectors.
(Note: if single
11 Center breastshields
pumping, insert port
over your nipples
plug into unused port.)
and start pumping.
(Caution: pushing
shields too firmly
onto breasts may
actually affect
milk flow.)
13 When your pumping session is over, store your breastmilk and clean
your kit. See section 2 for cleaning instructions.
7 Push yellow valves
onto inner rings of
connector bottoms.
10 Insert the
triangular two-
toned yellow ends
of tubing into
ports on pump
connector.
12 Turn pump on and
set vacuum regulator
ring to "MIN." Rotate
vacuum regulator
towards max to
adjust for comfort
once pumping
begins.
9
Tabla de contenido
