Storage; Winter Storage - Husqvarna W548 Manual Del Operador

STORAGE

Winter Storage

The machine should be readied for storage at the
end of the mowing season or if it will not be in use
for more than 30 days. Fuel that stands for long
periods of time (30 days or more) can leave sticky
residues that can clog the carburetor and disrupt
engine function.
Fuel stabilizers are a satisfactory option to
prevent the sticky residues that can occur during
storage.
Add stabilizer to the fuel in the tank or in the
storage container. Use the mixing ratios specified
by the manufacturer of the stabilizer. Operate the
engine for at least ten minutes after adding the
stabilizer so that it reaches the carburetor. Do not
empty the fuel tank and the carburetor if stabilizer
has been added.
Warning! Do not keep an engine with
fuel in the tank indoors or in poorly ventilated
spaces where fuel vapor can come in contact
with open flames, sparks, or a pilot light such
as in a boiler, hot water tank, clothes dryer,
etc. Handle the fuel with caution. It is very
flammable and can cause dangerous personal
injury and property damage. Drain the fuel
into an approved container outdoors and
keep far away from open flame or sources of
ignition. Do not use gasoline for cleaning. Use
a degreaser and warm water.
To ready the machine for storage:
1. Thoroughly clean the machine, especially
below the mower deck. Touch up damage
to the paint and spray a thin layer of oil on
the underside of the mower deck to prevent
corrosion.
2. Inspect the machine for worn or damaged
parts and tighten nuts or screws that may
have become loose.
3. Change the engine oil; dispose correctly.
4. Empty the fuel tank or add a fuel stabilizer.
Start the engine and let it operate until the
carburetor is drained of fuel or the stabilizer
has reached the carburetor.
5. Remove the spark plug and put about a
tablespoon of engine oil into the cylinder.
Turn over the engine so that the oil is evenly
distributed and then refit the spark plug.
6. Lubricate all grease zerks, joints and axles.
7. Remove the battery. Clean, charge and keep
the battery in a cool area and protected from
direct cold.
8. Keep the machine in a clean, dry area and
cover it for more protection.
Service
When ordering spare parts, please specify the
purchase year, model, type, and serial number.
Use genuine Husqvarna spare parts.
An annual check-up at an approved service
workshop is a good way to make sure that your
machine performs its best the next season.
29