Technical Specifications - Velleman CAMCOLBUL16 Manual Del Usuario

Ocultar thumbs

página de 17

/ 17
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Overview

Refer to the illustrations on page 2 of this manual.

heat-resistant fixed ring

heat-resistant waterproof ring

2mm tempered glass

heat-resistant fixed ring

light sensor + IR LEDs

video

power

cable exit - backside

cable exit - top

Installation

• Choose the location for the camera, keeping following guidelines in mind:

o do not install the camera in locations where extremely high or low temperatures or

excessive vibrations may occur.

o avoid mounting the camera near high electro-magnetic fields.

o do not aim the camera at the sun or other extremely bright objects or reflections (e.g.

metal doors).

o The connection cables run at the inside of the mounting bracket, and leave at the

backside [3] (default). They can be re-guided to leave via the top [4] or bottom [5] of

the mounting bracket.

• When the connection cables need to go through the wall, a hole of at least Ø20mm (max.

Ø35mm) must be foreseen at the mounting location.

• Guide the cables though the cable hole when applicable. Mount the mounting bracket on the

wall using 4 screws (included). Note that the camera must be resting on top of the

mounting bracket.

• Release hex screws [6] and [7] (hex key included) and point the camera to the desired

field of observation. Tighten hex screw [7] to secure the horizontal position and hex screw

[6] for the vertical position.

• Connect the video connector [1] to a monitor (not incl.).

• Connect the power connector [2] to a 12VDC power supply (not incl.).

• Manually adjust the zoom with screw [F] and the focus with screw [G]. These screws are

located at the back of the camera under protective caps. After adjusting, replace the

protective caps.

• The sunshield can be mounted or dismounted by sliding the sunshield towards the front of

the camera.