INSTRUCTION MANUAL CODE 80188 REV E
3
4
1
2
6
7
8
Fig. 5.1 Control panel
PARAMETERS PROGRAMMING
Factory settings:
Low level water alarm:
% heating:
Distillation power:
Volume of Boric acid:
Volume of HaOH:
J
.P. SELECTA s.a.u.
5.3 Parameters settings
These settings must be done in both modes: «MANUAL» and «AUTOMATIC»
Setting the distilling time:
•
- Press
- Use keys
•
Setting the "Low water level alarm" time (low level of water into
steam generator)
5
- Press
- Keep pressed keys
- Press
- Use
- Use
9
10
- Press
Setting the heating power on stand-by status:
•
- Press
- Keep pressed keys
- Press
- Use
36
- Use
5
- Press
80%
Setting distillation power:
•
4
- Press the keys
12
- Press
- Modify the value by means of keys
- Press
- Press
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Jun/2018
(It can be modified without notice)
.
to set the distilling time (minutes).
.
to select steam.
to set the alarm steam time (factory setting 36).
to validate the setting.
to save the setting and exit from the settings mode.
.
to select % stand-by heating.
to set to set the % heating (factory setting 5).
to validate the setting.
to save the setting and exit from the settings mode.
for 5 seconds until the display shows dashes.
and
until the display shows the current value.
and
to validate the setting.
to save and exit from the settings mode.
for a 10s until display shows dashes.
for a 10s until display shows dashes.
.
Tel 34 937 700 877 Fax 34 937 702 362
Page: 38