Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Jr.
Sodcutter
POSSIBLE
PROBLEM
Blade will not stay in
ground.
Root hair pinning on
side or bottom of
blade.
Belt jumps off.
Locking levers not
tight when pulled to
limit of travel.
Belt grabs in pulleys
and unit creeps when
clutch is not engaged.
Idler does not engage
belt when clutch lever
is moved forward.
TROUBLE SHOOTING CHART
PROBABLE
CAUSE
A. Bottom of blade is rounded off.
B. Blade angle is not properly set.
A. Some types of turf and soil make this a
problem.
A. Wrong type of belt construction.
B. Too much slack when belt tightener is
disengaged.
A. Thread wear on locking nut.
B. Locking nut not properly adjusted.
A. Belt is old and frayed, or is not the type
sent out with the unit.
B. Rust or paint in pulley grooves.
C. Engine set too far forward.
A. Brake band is not attached to clutch link or
is broken.
TROUBLE SHOOTING
REMEDY
A. Blade should be sharpened or
replaced. See page 8.
B. Adjust blade angle. See page12.
A. Keep the blade extra sharp and
ground back at a low angle.
A. Use only the special Ryan factory
belt.
B. Slide engine forward and
readjust control rod.
A. Replace locking nut.
B. Tighten locking nut on opposite
end of tie rod.
A. Belt should be replaced with
factory construction belt, designed
for belt tightener clutches.
B. Clean and polish pulleys.
C. Move engine back.
A. Reattach upper end of brake
band to clutch link or replace brake
band.
GB-19
Tabla de contenido
Solución de problemas
