Adjusting Depth Of Cut - Jacobsen RYAN JR. SODCUTTER Serie Manual De Servicio Y Piezas

Jr.
Sodcutter

ADJUSTING DEPTH OF CUT

1. Make a trial run in turf. Set depth to cut
approximately 3/4" of soil.
2. Loosen depth gauge handle. Adjust depth gauge
G to contact bottom on depth control lever D.
3. Loosen depth control locking lever E and lower
depth control D until it rests on depth gauge G.
4. Tighten depth control locking lever E.
NOTE: Numbers on depth gauge do not necessarily
represent thickness of sod being cut.
ADJUSTING OPERATOR PRESENCE CONTROL
1. To adjust operator presence cable, pull clutch
control handle A rearward as far as possible.
2. Press operator presence handle (right
handlebar) down as far as possible.
3. Adjust cable until the pivot arm C contacts the
arm extending from the operator presence
switch B.
4. Tighten cable clamp to secure cable. Check for
proper operation.
SERVICE
GB-13