Storage; Storage Instructions - Jacobsen RYAN JR. SODCUTTER Serie Manual De Servicio Y Piezas

STORAGE

STORAGE INSTRUCTIONS

To prevent possible explosion or ignition of
vaporized fuel, do not store equipment with fuel
in tank or carburetor in enclosure with open
flame (for example, a furnace or water heater
pilot light).
Daily Storage
1. Check engine oil level and air filter element
daily.
2. Check oil level in gear case.
3. Close fuel valve at bottom of fuel tank.
4. Clean cutting blade (grass, dirt, etc.).
Extended Storage
Before the equipment is put into storage for
any period exceeding 30 days, the following
steps should be taken:
1. Drain all fuel from fuel tank and lines (use a
hose or fuel line, routed from fuel tank shut-off to
proper container).
GB-18
2. Start engine and run until all fuel is used from
the carburetor float bowl.
3. While engine is warm, drain the crankcase oil
and replace with the proper weight of oil
corresponding to the season when the
equipment will next be used.
4. Remove the spark plug and squirt a small
quantity of engine oil into the cylinder. Turn the
engine over a few times to distribute the oil.
5. Lubricate all lubrication fittings.
6. Clean and oil cutting blade to prevent rust.
To put equipment into operation after an
extended storage:
1. Fill fuel tank with clean fresh fuel.
2. Check crankcase oil level, and start engine.
3. Check fuel system for fuel leaks.
Jr.
Sodcutter