Wayne Dalton Prodrive 3220C Instrucciones De Instalación Y Manual Del Propietario página 16

12
Installation of Wiring for Wired
Infrared Safety Sensor
Tools Needed: Uncoil the wires from the infrared safety
sensors and route the wire up the garage
Hammer wall across the ceiling and down to the back
of the opener. Tack the wires in place using
staples (Not Supplied). Take care to run
the wires in a location where they will not
interfere with the operation of the door and
do not staple through wire.
NOTE: If wires must be lengthened or
spliced into pre wired installation, use wire
nuts or other suitable connectors.
Wire to Opener
13
Connecting Wired Infrared Safety
Sensor to Opener
Tools Needed: Connect infrared safety sensors to the
opener as shown. Shorten wires as
Phillips Head necessary and separate wire ends. Strip
Screwdriver about 1/2" of insulation off each wire, being
careful not to nick wires, and attach wires
to the proper terminal screws, then tighten
Right Side Of Opener
securely, using phillips head screwdriver.
One wire has marking on it (numbers, black
stripe, etc). Be sure to observe polarity. Apply
tension to external wires to test for secure
connection. Check that the wires are stapled
in place properly.
Sending Unit
Receiving Unit
Black Strip
LED
Solid
Color
10
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com