Personal Protective Equipment; Danger Of Explosion; Before Use; Guidelines - Hilti DX 36 Manual De Instrucciones

5.1.6 Thermal safety precautions
a) Do not exceed the recommended fastener driv-
ing rate (number of fasteners driven per hour).
b) If the tool has overheated, allow it to cool down.
c) Do not dismantle the tool while it is hot. Allow
the tool to cool down.
d) The tool must be allowed to cool down if the
plastic cartridge strip begins to melt.

5.1.7 Danger of explosion

a) Use only cartridges of a type approved for use
with the tool.

6. Before use

NOTE
Read the operating instructions before the tool is
operated for the first time.
6.1 Checking the tool 2
WARNING
Do not operate the tool when parts are damaged
or when the controls do not function correctly. If

7. Guidelines

7.1 Fastening guidelines
These guidelines must be observed at all times.
NOTE
For detailed information, please ask your local Hilti sales and service office for a copy of the applicable technical
guidelines or national technical regulations.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069831 / 000 / 00
b) Remove the cartridge strip from the tool care-
fully.
c) Do not attempt to forcibly remove cartridges
from the magazine strip or tool.
d) Store unused cartridges in a locked place where
they are not exposed to dampness or excess-
ively high temperatures.

5.1.8 Personal protective equipment

The user and any other persons in the vicinity
must wear suitable eye protection, a hard hat and
ear protection while the tool is in use or when
remedying a problem with the tool.
necessary, have the tool repaired at an authorized
Hilti service center.
Check that no cartridge strip is loaded in the tool. If
there is a cartridge strip in the tool, pull it up out of
the tool by hand from above.
Check all external parts of the tool for damage and
check that all controls operate faultlessly.
Check the piston and spring clip for wear and ensure
that the parts have been fitted correctly.
en
25