Disassemble / Reassemble And Cleaning Of Rear Internals - Spyder Pilot with eye Manual Del Usuario

DISASSEMBLE / REASSEMBLE AND CLEANING OF REAR INTERNALS

REC032
REC033
Part Names and Numbers describe in this section:
Striker O-ring (#ORG001)
Receiver (#REC032/REC033)
Striker Spring (#SPR004)
Striker Bolt (#STB002)
Striker Buffer (#STF001)
QUICK CLEAN DISASSEMBLY
Lift upward on the Top Cocking Knob to disconnect the Delrin Bolt from the Striker Bolt. This will allow the Delrin Bolt to slide
out from the rear of the Receiver.
to clean with a squeegee.
Receiver. This will allow the Top Cocking Pin to correctly fasten with the Striker Bolt.
IMPORTANT: The air passage hole located in the middle of the Delrin Bolt should always be facing downward when
reinstalling. If the Delrin Bolt is not installed correctly, paintballs will not exit out of the barrel normally.
DISASSEMBLE OF REAR INTERNALS
STEP 1 Lift upward on the Top Cocking Knob to disconnect the Delrin Bolt from the Striker Bolt. This will allow the
Delrin Bolt to slide out from the rear of the Receiver.
STEP 2 Using an adjustable wrench (provided in the spare parts kit) turn the Striker Plug counter clockwise located
at the rear of the Receiver. This will allow all internal parts such as the Velocity Adjuster & Spring Guide, Striker
Spring, Striker Buffer and Striker Bolt to slide from the rear of the Receiver.
with the marker in the un-cocked position this will prevent the internals from springing out because the Striker
Spring is compressed.
the markers internals from springing out.
STEP 3 Remove items in order; Striker Plug w/Velocity Adjuster, Striker Spring and Striker Buffer.
STEP 4 Slide the Striker Bolt out of the rear of the Receiver.
would be wise to clean any dirt or paint from the inside of the Receiver with a squeegee and wipe the Delrin Bolt
clean with a rag or paper towel. Apply some paintball gun oil on Striker O-ring periodically.
IMPORTANT: It is not necessary to disassemble the rear internals for basic maintenance unless the Striker O-ring
needs to be replaced.
9
ORG001
HELPFUL TIP:
NOTE: Make sure the hole on the Striker Bolt is facing upright when looking thru the
HELPFUL TIP: Placing your finger behind the Striker Plug before removing this will prevent
VBT008
SPR004
STB002
Striker Plug (#STP026/STP033)
Top Cocking Knob (#STK008)
Delrin Bolt (#VBT008)
Velocity Adjuster/Spring Guide (#VTA026/VTA033)
Removing the Delrin Bolt from the Receiver will allow easy access
HELPFUL TIP:
STK008
STF001
STP026
STP033
VTA026
VTA033
NOTE: Remove the Striker Plug only
When the internals are removed it