Troubleshooting - Spyder Pilot with eye Manual Del Usuario

TROUBLESHOOTING

ONE OR MORE OF THE FOLLOWING MAY CAUSE RECOCKING RELATED ISSUES:
• Need lubrication on the following O-ring (#ORG001) (see Disassemble / Reassemble).
• The pressure in the tank is too low and possibly needs to be refilled.
• Striker O-ring (#ORG001) is damaged or missing. Replace with a new Kingman approved Striker O-ring.
NOTE: The Striker O-ring can not be substituted with a black or urethane bottle o-ring.
• Dirt or broken paint shell fragments in the receiver can cause the marker to have recocking issues. Using a
squeegee thru the upper portion of the receiver will remove most of the dirt or broken shell fragments. Should
this issue continue, (see Disassemble / Reassemble) remove the markers internals for complete cleaning.
• Using low quality paintballs can cause the marker to experience recocking issues because of the shape of
the paintballs.
Paintballs can take a different shape over time, so it would be wise to size the paintball with your barrel.
ELECTRONIC TRIGGER FRAME TROUBLESHOOTING
• If your marker is not shooting it may be due to one of the following problems:
• Battery may need to be recharged.
• The Battery Wire Harness is not properly attached to the circuit board.
• The Coil Set Harness is not properly attached to the circuit board.
• The Touch Switch Harness is not properly attached to the circuit board.
have any dirt or paint, Kingman recommends using an aerosol can of air. Apply the can of air directly at the
components that need cleaning.
13
HELPFUL TIP: Paintballs have a shelf life and can become too fragile for use. HELPFUL TIP:
NOTE: If the Markers Electronics