Cup Seal Removal - Spyder Pilot with eye Manual Del Usuario

CUP SEAL REMOVAL

LPC026
LPC033
SPR013
Part Names and Numbers describe in this section:
Foregrip Expansion Chamber (#FRG026/FRG033)
Cup Seal Guide (#ITP011)
Cup Seal (#ITP012)
Valve Pin (#ITP017)
M5x20 Vertical Washer (# ITP019)
STEP BY STEP CUP SEAL ACCESS
Access of the cup seal for service or replacement requires the removal of the Front Plug and Vertical CA Adapter.
STEP 1 Unscrew the Foregrip Expansion Chamber from the Vertical CA Adapter.
STEP 2 Remove the Vertical CA Adapter by unscrewing the Vertical CA Adapter Mounting Screw, be sure to keep a
finger over the Front Plug to prevent it from springing out.
held in place by the Vertical CA Adapter Mounting Screw.
STEP 3 Pull the Front Plug out and it should come out with the Valve Spring, Cup Seal Guide, Cup Seal and Valve
Pin all together.
STEP 4 Unscrew the Cup Seal from the Valve Pin and replace with the spare provided with your spare parts kit.
STEP 5 Follow the previous steps in reverse to re-install all components properly. Make sure the Front Plug screw
hole is lined up with the vertical adapter screw hole.
IMPORTANT: Always make sure all air sources have been removed from your marker and any residual air has been
vented out completely before servicing your marker.
NOTE: Service or replacement of the Cup Seal should only be done if a leak is present and can be heard from the
breach after the removal of the Delrin Bolt.
ITP012
ITP017
ITP011
ITP019
FRG026
FRG033
VRT026
VRT033
SCR027
Front Plug (#LPC026/LPC033)
Valve Spring (#SPR013)
Vertical Adapter (#VRT026/VRT033)
Vertical Adapter Mounting Screw (#SCR027)
NOTE: The Front Plug and Vertical CA Adapter are both
English
12