Surix iP Access Manual Del Usuario página 23

Installation
Proceed with the product installation, according to the product purchased.
Model: Flush mount
• Remove the screw from the botton plastic part
(picture shows the external mounting box )
• Slide down the front cover of the product and
separate
the cover of the wallbox
• ATTENTION: The wallbox has a mounting
orientation,
DO NOT reverse it.
• The wallbox has weakened areas for the
entrance of
wires; drill the correct one.
• Set the box to the wall into the hole made to
accommodate it.
• Enter the power wires and UTP into the box.
• Connect the wires to the connectors on the circuit (see next section)
• Reset the cover to the wallbox, beginning with fitting the top screw and, pushing
gently upwards, put the screw of the botton plastic part.
Model: Surface mount
• Remove the screw from the botton plastic part.
• Remove the botton plastic part by sliding down it.
• Separate the front cover of the external mounting
plastic box. The hobbles of the box that lock the cover,
are quite hard. If necessary, make pressure between
the box and the front cover with the same screwdriver
used to remove the screw.
• Set the box to the wall using the fixing holes
• Enter the power wires and UTP into the box.
• Connect the wires to the connectors on the circuit (see next section)
• Reset the cover to the wallbox, beginning with refitting the front cover in the box and
then, put the screw of the botton plastic part.
Página 23 de 39
Manual de Portero IP v 9.0
SURiX IP Access
Versión de software (desde) 3.20